Table of Contents
Advertisement
16 [Maintenance] to maintain the machine
16.5 [Data] to back up/restore configuration logs
[Setup data]
You can back up the computer's settings to your computer by clicking [Execute].
[Scene file]
By clicking on [Execute], you can back up the scene file settings for your computer.
[Logs]
You can back up your computer's logs by clicking [Execute].
Restore
[Setup data]
Press the [Select File] button to select the file of the set data to be restored.
Click the radio button to select whether to restore the network settings at restore time.
When [Execute] is clicked, restores start. After the restore is completed, the system restarts. Do
not operate the screen until the restore is completed.
Be sure to use [Model name.dat] (model name is lowercase and [WV-] is not required) as the file
name of the setting data to be used for restore.
[Important]
・It takes a long time to create a backup file when backing up configuration data
and logs.
・If the backup operation takes more than 10 minutes, a communication timeout
may occur. At this time, the backup data may not have been obtained completely,
so please complete it within 10 minutes. You can also check whether the correct
data was obtained by restoring the acquired data. (excluding log data)
[Important]
・If it takes more than five minutes to restore the setting data, the restore may
have failed due to the disconnection of the communication.
Restore the system again.
[Note:]
・Restore operations for setup data are not applied to IEEE 802.1X related settings.
・Restore operations for setup data are not applied to the following network related
settings.
– [Line speed]
459
Advertisement
Table of Contents
