Table of Contents
Advertisement
7 [Easy Setup] to use easy setting
7.3 [Event action] for setting events
Alarm linkage operation
[Terminal alarm 1]
Select the action to be interlocked when terminal alarm 1 is detected from the following. This can
be set when [Terminal 1] of the alarm is set to [Alarm input(TRM1)].
[Off]:Interlock operation is not performed even if terminal alarm 1 is detected.
1～256:When the preset position registered in advance is selected, the watch moves to the preset
position when terminal alarm 1 is detected.
[Patrol 1]:When terminal alarm 1 is detected, patrol starts.
*When Patrol 1 is not registered, it is not displayed.
[Terminal alarm 2]
Select the action to be interlocked when terminal alarm 2 is detected from the following. This can
be set when [Terminal 2] of the alarm is set to [Alarm input(TRM2)].
[Off]:Interlock operation is not performed even if terminal alarm 2 is detected.
1～256:When the preset position registered in advance is selected, it moves to the position when
terminal alarm 2 is detected.
[Patrol 2]:When terminal alarm 2 is detected, patrol starts.
*When Patrol 2 is not registered, it is not displayed.
[Terminal alarm 3]
Select the action to interlock when terminal alarm 3 is detected from the following. This can be set
when [Terminal 3] of the alarm is set to [Alarm input(TRM3)].
[Off]:Interlock operation is not performed even if terminal alarm 3 is detected.
1～256:Select the preset position registered beforehand to move to the position when terminal
alarm 3 is detected.
[Patrol 3]:When terminal alarm 3 is detected, patrol starts.
*When Patrol 3 is not registered, it is not displayed.
[Note:]
・Alarm detection time is managed for each alarm type. For example, the operation
detection alarm is detected even when the alarm of terminal alarm 1 is not
detected.
179
Advertisement
Table of Contents
