Table of Contents
Advertisement
12 [Alarm] to set the alarm
12.7 [SCD area] to set up undesired detection
[Camera selection]
Select the camera to set the area from each camera.
[Area]
・If you configure the disturbance detection area and then change the [Image
rotation] or [Image] tab [Image capture mode] on the [Basic] tab, the disturbance
detection area may shift. Be sure to reconfirm the settings of the disturbance
detection area.
・In the following cases, disturbance detection may not be detected.
If only part of the screen is covered or transparent
-when the camera is oriented in a similar manner before and after the camera
-if a privacy zone is set
・If the [Detection Time] setting of the disturbance detection function is shorter
than the [Dwell time] setting of the [Black-and-white switching], the disturbance
detection alarm may be generated when the color image and black-and-white
image are switched. The [Detection Time] setting of the disturbance detection
function can be improved by making it longer than the [Dwell time] of [Black/
white switching].
・When the color of the image is close to monochrome, it is difficult to detect
disturbance. If undesired detection is difficult, increase the [Detection sensitivity]
setting of the undesired detection function or increase the area of the undesired
detection function.
・When [Intelligent Auto] is set to [On], the undesired detection alarm may be
generated because the brightness of the entire image changes depending on the
subject's condition. In this case, set one of the following settings.
-Set [Detection sensitivity] to a low setting.
-Set [Detection Time] for a long time.
-Adjust the [Face priority level (Brightness)] slider bar of the intelligent auto to
[-].
・The disturbance detection function is not used to prevent theft, fire, etc. We will
not be liable for any accident or damage.
[Note:]
・[MULTI] [Camera selection] can be selected only for Multi-directional cameras.
360
Advertisement
Table of Contents
