Table of Contents
Advertisement
2 Operation
2.7 Display the log list
(Previous page) button:Displays the log list for the previous page.
(Next page) button:Displays the log list for the following pages.
(Last) button:Displays the last log.
[Time & data]:Displays the date and time the log was recorded.
[Duration]:Displays the length of time data was saved on the SD Memory Card.
[Event]:Displays the cause of the log.
-MN/SC: Logs by Manual Save and Schedule Save
-TRM1: Alarm caused by alarm input to terminal 1
-TRM2: Alarm caused by alarm input to terminal 2
-TRM3: Alarm caused by alarm input to terminal 3
-VMD: Alarm due to operation detection alarm
-SCD: Alarm due to undesired detection alarm
-COM: Command Alarm
-AT: Alarm due to automatic tracking alarm
-INT: Intrusion alarm by AI-VMD
-LOI: Alarm on AI-VMD
[Note:]
・If [Time display format] is set to [24h], the alarm date and time is displayed in
24-hour format.
・The timing of logging is as follows.
–[Alarm Log]:The date and time of the alarm is logged.
–[Manual/Schedule Save Log]:The date and time when saving to the SD Memory
Card was started by manual or schedule setting is recorded as a log. To save
continuously, logs are logged at hourly intervals (12 o'clock, 1 o'clock, 2 o'clock,
etc.) when [Recording format] is JPEG. Also, when [Recording format] is
streamed, logs are logged every hour from the beginning of recording.
[Note:]
・The difference between the recording end time and the recording start time is
rounded to the nearest 0.1 second. Therefore, when only one JPEG image is
recorded, the recording time is displayed as 00:00:00.
121
Advertisement
Table of Contents
