Table of Contents
Advertisement
10 Set PTZ
10.2 [Position] for setting positions
[Dwell time]
During the preset sequence operation, select the time to reflect the image of each preset position
(the time when the camera stops rotating) from the following.
[5s]/ [10s]/ [15s]/ [20s]/ [25s]/ [30s]
[Super Dynamic]
You can set [On] or [Off] to activate the super dynamic function. You can set for each preset
position.
This cannot be set when [Image capture mode] is [16:9 mode(60fps mode)] or [16:9 mode(50fps
mode)].
See [What is Super Dynamic] for details on super dynamic.
[On]:The Super Dynamic function is activated.
[Off]:Stops the superdynamic function.
[Note:]
・When presetting a subject whose depth does not change, a subject whose
contrast is low, or a subject with high brightness such as a spotlight, etc., set
[Off] and register the preset position after setting the focus.
[Note:]
・The preset position set to [Off] does not move to that position during the preset
sequence, but instead moves to the next preset position.
・Depending on the stop time setting, the watch may move to the next preset
position during auto focus operation.
・If the preset sequence function is used for a long time, the drive parts may be
consumed and the replacement cycle of consumables may be faster. For
consumables, refer to the Web Guide.
[Note:]
・Set [Super Dynamic] to [Off] when the following phenomena are observed
depending on the lighting condition.
-when flickering or color changes occur
-when noise is generated in the bright area of the screen
・If [Light control mode] is set to [Fix shutter], [Super Dynamic] cannot be set to
[On].
・When [Stabilizer] is set to [On], the superdynamic setting is [Off].
・[Rapid PTZ-8M (4K)][Rapid PTZ-6M]If you switch the [Super Dynamic] from
[On] to [Off] or from [Off] to [On], the images may be distorted.
311
Advertisement
Table of Contents
