Table of Contents
Advertisement
2 Operation
2.3 Viewing images from a PC
→3.7 [Audio] for setting sound
• If [Audio transmission mode] is set to [Mic input] or [Interactive(Full-duplex)] [Interactive
(Half-duplex)]
• If [Audio input encoding format] is set to [AAC-LC]
Buttons, You can adjust the earpiece volume in four steps: [Off], [Low], [Middle], and
[High] by clicking on buttons or by moving the volume cursor.
Click the Listen button to turn on/off the earpiece voice (heard on PC).
⑰[Camera Control Panel]-[AUX] Buttons
This setting is available only when [Terminal 3] of [Alarm] is set to [AUX output] in the
Advanced menu.
→7.3.2 Alarm: Sets terminal and operation detection (alarm setting screen)
[Open] buttons:The AUX terminal is open.
[Close] buttons:The AUX terminal will be closed.
⑱[Camera Control Panel]-[Playback of recording (Log disp.)]
Clicking [Start] displays the log list and plays back the images stored on the SD Memory Card.
[Note:]
・When [Audio volume control mode] is set to [Adjust Mic input] in the Setup
menu, the volume cursor is not displayed when using [Audio recording] or [Audio
detection].
→3.7 [Audio] for setting sound
・When the computer is restarted, the earpiece volume changed by the volume
cursor returns to the earpiece volume set in the [Audio] tabs of the setting
menus.
→3.7 [Audio] for setting sound
・On the screen, the volume cursor can be fine-tuned, but actually it is set to one
of four levels of volume.
・If you open multiple camera browsers simultaneously on the same PC, you cannot
hear the sound of the camera browser opened later. Access and check one by one.
・If network communication is unstable, voice reception may be stopped. In this
case, restart voice reception by turning on and off the earpiece button.
[Note:]
・The names of [AUX], [Open], and [Close] can be changed.
→12.3 [Alarm] to change the aux name
52
Advertisement
Table of Contents
