Alarm: Sets Output Terminal - i-PRO WV-X86531-Z2-PTZ User Manual

7 [Easy Setup] to use easy setting
7.3 [Event action] for setting events
Select whether to record before alarm. Sets the time to save to the SD Memory Card.
[Off]/ [1s]/ [2s]/ [3s]/ [4s]/ [5s]/ [8s]/ [10s]/ [15s]/ [20s]/ [25s]/ [30s]/ [40s]/ [50s]/ [60s]/
[90s]/ [120s]
[Post alarm (recording) duration]
Sets the time to save to the SD Memory Card after an alarm is generated.
[10s]/ [20s]/ [30s]/ [40s]/ [50s]/ [60s]/ [120s]/ [180s]/ [240s]/ [300s]
[Next] buttons
Select [Alarm output] in the Alarm Settings window and press [Next] to open the Alarm Outputs
dialog box.
→7.3.5 Alarm: Sets output terminal.
If you do not select [Alarm output] on the Alarm Settings screen and [Next] is clicked, the Mail
Settings screen is displayed.
→7.3.6 Alarm: Configuring mail notification and mail server
[Back] button
Returns to the previous screen.
7.3.5

Alarm: Sets output terminal.

The alarm output is set here. This message is displayed when [Alarm output] is selected in the
alarm setting window.
To set the output terminal:
[Note:]
・The values that can be set depend on the resolution and bit rate of the stream to
be recorded. The higher the bit rate, the smaller the maximum value that can be
set as the pre-alarm time.
[Note:]
・Clicking [Next] saves the settings in the window.
[Note:]
・Refer to the catalog specifications for the functions installed in each model.
186