Table of Contents
Advertisement
2 Operation
2.4 Viewing images from mobile/tablet terminals
⑩[Auto focus]
Use [Auto] and [Off] to set whether auto focus is performed after the preset is moved. You can
set for each preset position.
[Auto]:Auto focus is performed after the preset is moved.
[Off]:Auto focus is not performed after moving the preset.
[Stopping time]
During the preset sequence operation, select the time to reflect the image of each preset
position (the time when the camera stops rotating) from the following.
[5s]/ [10s]/ [15s]/ [20s]/ [25s]/ [30s]
⑪[Zoom]
Adjust the zoom manually.
[-]:Adjust the zoom factor to 1.0 times in the [Wide Angle] direction.
[x1]: Zoom (magnification) is 1.0 times.
[+]:Adjust the zoom factor in the [Telescope] direction.
⑫[Focus]
Adjust the focus manually.
[Auto]:Automatically adjust focus.
[Near]:Adjust the focus to the [Near].
[Far]:Adjust the focus to the [Far].
[Note:]
・When presetting a subject whose depth does not change, a subject whose
contrast is low, or a subject with high brightness such as a spotlight, etc., set
[Off] and register the preset position after setting the focus.
[Note:]
・The preset position set to [Off] does not move to that position during the preset
sequence, but instead moves to the next preset position.
・Depending on the stop time setting, the watch may move to the next preset
position during auto focus operation.
・If the preset sequence function is used for a long time, the drive parts may be
consumed and the replacement cycle of consumables may be faster. For
consumables, refer to the Web Guide.
108
Advertisement
Table of Contents
