Table of Contents
Advertisement
8 [Basic] for basic setup of the machine
8.2 [SD memory card] for setting SD Memory Cards
[Manual]:Save the image manually.
[Schedule]:Save the image according to the schedule settings. This option is available only when
[Stream] is selected in [Recording format].
→15 [Schedule] for scheduling
When [Alarm input] is selected in [Save trigger], the alarm type can be selected from the following.
[Terminal 1]:The image is saved when an alarm is generated at terminal 1.
[Terminal 2]:Image is saved when alarm is generated at terminal 2.
[Terminal 3]:The image is saved when an alarm is generated at terminal 3.
[VMD]:Image is saved when operation detection occurs.
[SCD]:The image is saved when undesired detection occurs.
[Auto track]:Save the image when auto tracking occurs.
[Command alarm]:Saves the image when a command alarm is entered.
JPEG manual storage recording
This setting is available only when [Recording format] is set to [JPEG(1)] or [JPEG(2)] and [Save
trigger] is set to [Manual].
[File name]
Enter the file name for saving images to the SD Memory Card. The following file names are
actually saved.
[Note:]
・If [Recording format] is streamed, [FTP/SFTP periodic image transmission error]
cannot be set.
・To generate an alarm, use the [Alarm] tabs to set the alarm.
・If [Recording format] is [JPEG], [Schedule] cannot be set.
・When connected to our network disk recorder, [Save trigger] may be grayed out
by [Network failure]. To change the [Save trigger] setting after you disconnect
the recorder, set [SD memory card] to [Not use] and then set [Use] again.
・If [GOP control] is set to Advanced (Fixed GOP 60s + 1s keyframe), alarm
recording cannot be set.
・Images are not recorded when sound detection alarm is generated.
214
Advertisement
Table of Contents
