Table of Contents
Advertisement
7 [Easy Setup] to use easy setting
7.3 [Event action] for setting events
[Terminal 3]
Set the operation of terminal 3.
・[Off]:Terminal function is not used.
・[Alarm input (TRM3)]:The alarm input is received.
・[Short circuit]:When the terminal status changes to [On], an alarm is detected.
・[Open]:When the terminal status changes to [Off], an alarm is detected.
・[Short circuit (Continued)]:When the terminal status changes to [On], an alarm is detected.
When the terminal status is [On], the alarm is detected periodically at intervals of no alarm
detection time.
・[Open (continued)]:When the terminal status changes to [Off], an alarm is detected. When the
terminal status is [Off], the alarm is detected periodically at intervals of no alarm detection time.
・[Aux output]:AUX output is performed. The [AUX] buttons appear on the live picture pages.
[VMD alarm]
On:If the motion detection area is not set, the entire area is set. To set the operation detection
area, use the [VMD area] tab on the alarm page.
→12.6 [VMD area] to set the motion detection area
[Off]:Disables all operation detection status.
[Scene change detection (SCD) alarm]
[On]:If the disturbance detection area is not set, the entire area is set. To set up the undesired
detection area, use the [SCD area] tab on the alarm page.
→12.7 [SCD area] to set up undesired detection
[Off]:Disables all disturbance detection conditions.
[Audio detection alarm]
[On]:Use the sound detection alarm. All AI sounds are recognized.
→12.9 [Audio detection] for setting sound detection
[Off]:Sound detection alarm is not used.
[Alarm deactivation time]
Sets the time when the alarm is detected and the detection operation is not executed. For
example, if you set up an e-mail notification to a mobile terminal or a tablet terminal using an
alarm, this setting prevents you from sending too much e-mail.
5-[600 seconds]
178
Advertisement
Table of Contents
