i-PRO WV-X86531-Z2-PTZ User Manual page 414

14 Networking configuration [Network]
14.2 [Advanced] for advanced networking settings
[1 pic]/[2 pics]/[3 pics]/[4 pics]/[5 pics]/[6 pics]/[7 pics]/[8 pics]/[9 pics]/[10 pics]/[20
pics]/[30 pics]/[50 pics]/[100 pics]/[200 pics]/[300 pics]/[500 pics]/[1000 pics]/[1500
pics]/[2000 pics]/[3000 pics]
[Recording duration]
Approximate time to be taken to save the set [Number of images] with the set [Transmission
interval] willbe displayed.
[Image capture size]
Select the image capture size of images transmitted when an alarm occurs from the following.
JPEG(1)/JPEG(2)
Alarm setting (server 2)
[Alarm image transmission]
Select [On] or [Off] to determine whether or not to transmit images when an alarm is detected.
[On]：Transmits an image to the server when an alarm has occurred.
[Off]：Does not transmit an image to the server when an alarm has occurred.
[Directory name]
Enter the directory name where the alarm images are to be saved.
For example, enter [/ALARM] to designate the directory [ALARM] under the root directory of
the server.
Number of characters that can be entered:1 to 256 characters
Characters that cannot be entered:Double-byte and single-byte symbols " & ;
[File name]
Enter the file name used for the alarm image to be transmitted to the server. The file name will be
as follows.
File name:File name entered + Date and time (year, month, day, minute, second) + Sequence
[Note:]
・If the resolution of the image to be transmitted is set to JPEG(1), and the
JPEG(1) resolution is larger than [1920×1080], the maximum refresh interval will
be 1fps.
・If the refresh interval is higher than 1fps, the maximum number of pre-alarm
images is 10.
[Note:]
・[New X Fixed-8MP][New X Fixed-6MP][Alarm image transmission] is not
available when [Image capture mode] is set to [60fps Mode] or [50fps Mode].
407