Table of Contents
Advertisement
14 Networking configuration [Network]
14.2 [Advanced] for advanced networking settings
FTP server 1 setting
FTP server 2 settings
[FTP server address]
Enter the IP address or host name of the FTP server that sends the image.
Number of characters that can be entered:1 to 128 characters
Input Characters:One-byte alphanumeric and one-byte symbols : . _ -
[User name]
Enter the user name (login name) to access the FTP server.
Number of characters that can be entered:1 to 32 characters
Characters that cannot be entered:Double-byte and single-byte symbols " & : ; ¥
[Password]
Enter the password to access the FTP server.
Number of characters that can be entered:0 to 32 characters
Characters that cannot be entered:Double-byte and single-byte symbols " &
[Control port]
Enter the control port number of the FTP server.
Configurable port number:1～65535
The following port numbers cannot be set because they are used by this computer.
20、 21、 22、 23、 25、 42、 53、 67、 68、 69、 80 110、 123、 161、 162、 443、 554、 995、
1883、 8883、 10669、 10670、 59000～61000
[Recording priority]
[Note:]
・If [Transmission protocol] is set to SFTP, you cannot configure the FTP server.
[Important]
・If you want to enter a hostname for [FTP server address], you must configure the
DNS on the [Network] tab of the network page.
→14.1 Networking [Network]
[Note:]
・[MULTI] The port numbers 32768 to 49151 cannot be set.
411
Advertisement
Table of Contents
