Table of Contents
Advertisement
14 Networking configuration [Network]
14.2 [Advanced] for advanced networking settings
Occurrence time:The occurrence time %t% is added to the message text. The %t% is replaced by
the time the alarm occurred (hour: minute: second).
[Terminal 1 (Up to 10 characters)]
Enter the name of Terminal 1 used for alarm factors in the mail body.
Characters that cannot be entered:Single-byte characters " &
[Terminal 2 (Up to 10 characters)]
Enter the name of terminal 2 used for alarm factors in the mail body.
Characters that cannot be entered:Single-byte characters " &
[Terminal 3 (Up to 10 characters)]
Enter the name of terminal 3 used for alarm cause in the mail body.
Characters that cannot be entered:Single-byte characters " &
Mail notification example
Mail format when checkbox for camera title is specified in mail subject and check box for alarm
factor/occurrence time is specified in mail body
For the disturbance detection alarm of camera 4: "SCD(CH4)"
[Note:]
・If the SD Memory Card has no free space, [SD Memory Card is FULL] or [SD
Memory Card cannot be recognized] is sent.
・By describing the substitute characters in the message text, the cause type and
the time of alarm can be automatically assigned.
Alternate character alarm factor: %p%, occurrence time: %t%
(Example of Use)
When the operation detection alarm is generated at 19:13:24 after setting the
following character string in the mail body.
Set mail text: %p%alarm occurred at %t%.
Message text: ["VMD" alarm was generated at 19:13:24].
If the body is blank, the email languages that are sent are determined by the
[Menu language] of the [Basic].
Specifying [Japanese] sends e-mail in Japanese or in other languages.
401
Advertisement
Table of Contents
