Table of Contents
Advertisement
12 [Alarm] to set the alarm
12.5 [VMD area] for setting motion detection
[Status]
Enable/disable operation detection.
[Enable:Operation detection is performed.
[Disabled:Operation detection is not performed.
[Detection area]
Set the area for detecting movement of object in the motion detection area with the slider bar.
The smaller the set value, the smaller the object movement will be detected. The current setting
(1 to 10) is displayed to the right of the slider bar.
[Detection sensitivity]
Use the slider bar to set the sensitivity for detecting movement in the area. Individual settings can
be made for each area. The larger the set value, the easier it is to sense the movement.
The current setting (1 (Low) to 15 (High)) is displayed under the slider bar.
[Delete] buttons
Click the area button to delete the area frame.
[Light detection control]
Use the [On] and [Off] buttons to specify whether or not the operation is not detected due to
changes in the illumination.
[Area No. notification]
Clicking [TCP alarm notification setup >>] displays the [Transmission] tabs on the Alarm Page.
→12.1 [Alarm] to set alarm operation
Addition of motion detection information
[Information addition]
Adds motion detection information to images and sets on/off whether to transmit superimposed
[Important]
・If the lighting intensity is small, it may be impossible to suppress it.
・When the illumination detection suppression is set to [On] and a object
movement is detected throughout the window, operation detection may not be
performed.
・If [Camera title on screen display] is set to [On], the accuracy of motion
detection may be reduced.
352
Advertisement
Table of Contents
