Table of Contents
Advertisement
3 Setting
3.4 [Image quality] for setting image quality
・[Common(Cam. 1-2)]: Sets the same settings for the cameras.
・[Camera 1]: Sets camera 1 image quality.
・[Camera 2]: Sets camera 2 image quality.
・[Camera 3]: Sets the image quality of camera 3.
・[Camera 4]: Sets camera 4 image quality.
・ [Brightness]
Adjust the brightness.
Move the slider bar in the [+] direction to brighten the image.
Move the slider bar in the [-] direction to darken the image.
Press [Reset] to return to the default brightness.
・ [Sharpness level]
Adjust the sharpness level (contour correction).
Moving the slider bar in the direction of [+] results in a sharp contour, and moving the slider
bar in the direction of [-] results in a soft contour.
Press [Reset] to return to the default settings.
・ [Maximum gain]
Adjust the maximum gain. When the subject's illumination becomes dark, the gain automatically
increases and the screen brightens.
Increasing the gain may increase the noise.
Move the slider bar in the [+] direction to increase the maximum gain.
Move the slider bar in the [-] direction to reduce the maximum gain.
Press [Reset] to return to the default settings.
・ [Digital noise reduction]
The digital noise reduction function automatically reduces noise at low illumination levels.
Move the slider bar in the direction of [+] to increase the effect of noise reduction. There may
be a lot of afterimages.
Moving the slider bar in the direction of [-] reduces the noise reduction effect. There are fewer
aftereffects.
Press [Reset] to return to the default settings.
・ [Super Dynamic]
On/Off is used to specify whether or not the super dynamic function can be activated.
・ [Light control mode]
Select the mode to control the light intensity.
・ [Maximum shutter]
The maximum exposure time adjusts the maximum storage time of the sensor.
・ [D&N]
138
Advertisement
Table of Contents
