Table of Contents
Advertisement
8 [Basic] for basic setup of the machine
8.1 [Basic] to perform basic settings
frequently swings. It is effective to reduce the vibration.
Check the operation during installation.
Do not use the shaking correction function when using the product in an environment where there
is no shaking.
[Important]
・When set to [On], the field angle is narrowed. When set to [On], check the field
angle when mounting the camera.
・Picture correction does not work in the following cases.
Pan and tilt zoom are executing.
During position refresh
・In the following cases, it may not be possible to obtain sufficient shaking
compensation depending on the shooting conditions.
When the subject is dark
-Rapid oscillation, such as mechanical vibration
Large-amplitude shaking
-Image quality/position setting in progress
・If the [Stabilizer] setting is changed with the following area set, the set area will
be misaligned. Set [Stabilizer] and then set the respective areas.
-Mask area
-Privacy Zone
-Operation detection area
-VIQS area
・[New X Fixed]This function is not available when [Image capture mode] is set to
[60fps Mode] or [50fps Mode].
・[New X Fixed]If you change the setting from [On] to [Off], it restarts automatically.
・[New X Fixed]When set to [On], [90°] and [270°] of [Image rotation] cannot
be used.
・[New X Fixed]When set to [On], [Lens distortion compensation] cannot be used.
・[New X Fixed-2M]When set to [On], the zoom factor is limited to up to 3.1
times.
・[New X Fixed-8M][New X Fixed-6M]When set to [On], [Frame Rate] is limited
to the highest 15fps.
・[New X Fixed-8M][New X Fixed-6M]When set to [On], the zoom factor is
limited to up to 2 times.
204
Advertisement
Table of Contents
