Table of Contents
Advertisement
12 [Alarm] to set the alarm
12.1 [Alarm] to set alarm operation
–[Open (continued)]:When the terminal status changes to [Open], an alarm is detected. When the
terminal status is [Open], the alarm is detected periodically at intervals of no alarm detection
time.
[Aux output]:AUX output is performed. The [AUX] buttons appear on the live picture pages.
[VMD alarm]
Clicking [VMD] displays the [VMD area] tabs on the Alarm Page.
→12.6 [VMD area] to set the motion detection area
[Scene change detection (SCD) alarm]
Clicking [SCD] displays the [SCD area] tabs on the Alarm Page.
→12.8 [SCD area] to set up undesired detection areas
[Auto track alarm]
Clicking [Auto track setting] displays the [Auto track alarm setting] tabs for the PTZ pages.
→10.4 Set Auto Track Alarm (Auto Track Alarm screen)
[Audio detection alarm]
Clicking [Audio detection] displays the [Audio detection] tabs on the Alarm Page.
→12.9 [Audio detection] for setting sound detection
[Command alarm]
Use [On] or [Off] to specify whether or not to accept the command alarm.
Command alarm is a function to receive unique alarm notification from other cameras. When set to
[On], the alarms can be operated in conjunction with several cameras.
[Reception port]
[Important]
・It takes approximately 100 ms or longer to detect an alarm input to a short circuit
(ON) or an alarm input to an open circuit (OFF) of the external I/O terminal. The
alarm input will not be detected until the time set by [Alarm deactivation time]
has elapsed.
[Note:]
・AUX is a camera terminal that can be operated (opened/closed) by the operator
from the live image page. For example, when you want to operate lighting in the
location where the camera is installed, you can operate it remotely by connecting
it to a lighting control device.
・For the input/output ratings of each terminal, refer to the installation manual of
the model.
336
Advertisement
Table of Contents
