Table of Contents
Advertisement
2 Operation
2.4 Viewing images from mobile/tablet terminals
④[SD Storage Status Display]
Displays the storage status on the SD Memory Card. When saving starts, the SD save status
indicator turns red. The LED turns OFF when saving stops.
This is displayed when the [Save trigger] in the Setup menu is set to [Manual] or [Schedule].
→8.2 [SD memory card] for setting SD Memory Cards
⑤[Main area]
Live displays the camera image.
⑥[Capacity display]
The remaining capacity and total capacity of the SD Memory Card are displayed.
⑦[Super dynamic setting]
You can set [On] or [Off] to activate the super dynamic function. You can set for each preset
position. This cannot be set when [Image capture mode] is in [60 fps mode] or [50 fps mode].
See [What is Super Dynamic] for details on super dynamic.
[On]:The Super Dynamic function is activated.
[Off]:Stops the superdynamic function.
⑧[Light control mode] pull-down menu
Select the mode to control the light intensity from the following.
[Outdoor shooting]:The brightness (illumination) controls the light intensity by combining the
electronic shutter and automatic aperture. This setting is used when shooting bright subjects
such as outdoors. Be careful not to flicker under fluorescent lights, etc.
[Flickless (50 Hz)]/[Flickless (60 Hz)]:Flicker is automatically corrected with a fluorescent
lamp. 50 Hz/60 Hz will be used differently in different regions.
[Note:]
・The alarm notification button blinks in conjunction with the alarm notification
operation such as mail transfer. Check the operation setting.
[Note:]
・Set [Super Dynamic] to [Off] when the following phenomena are observed
depending on the lighting condition.
-when flickering or color changes occur
-when noise is generated in the bright area of the screen
・If [Light control mode] is set to [Fix shutter], [Super Dynamic] cannot be set to
[On].
・When [Stabilizer] is set to [On], the superdynamic setting is [Off].
105
Advertisement
Table of Contents
