2 Operation
2.3 Viewing images from a PC
After the manual operation is completed, select the time before returning to the operation set
by [Self return].
㉒[Alarm notification]
When an alarm is generated, it is displayed as a popup. Clicking the [X] button resets the
output terminal and the display disappears.
→2.6 Operation when alarm is generated
㉓[Camera Control Panel]-[Brightness]
It can be adjusted from 0 to 255. Clicking the button brightens the image. Click the button
to darken the image. Click the button to return to the default settings.
㉔[Camera Control Panel]-[Mic input volume (Camera to PC)]
This item can be set in the following settings.
→3.7 [Audio] for setting sound
• If [Audio transmission mode] is set to [Mic input] or [Interactive(Full-duplex)] [Interactive
(Half-duplex)]
• If [Audio input encoding format] is set to [AAC-LC]
Buttons, Click the button or move the volume cursor to adjust the earpiece volume in four
steps: Off/weak/medium/strong.
Click the Listen button to turn on/off the earpiece voice (heard on PC).
[Note:]
・The alarm notification is not linked to the alarm notification operation such as
recording to the SD Memory Card or mail transfer. Check the respective
operation settings.
[Note:]
・When [Audio volume control mode] is set to [Adjust Mic input] in the Setup
menu, the volume cursor is not displayed when using [Audio recording] or [Audio
detection].
→3.7 [Audio] for setting sound
・When the computer is restarted, the earpiece volume changed by the volume
cursor returns to the earpiece volume set in the [Audio] tabs of the setting
menus.
→3.7 [Audio] for setting sound
・On the screen, the volume cursor can be fine-tuned, but actually it is set to one
of four levels of volume.
・If you open multiple camera browsers simultaneously on the same PC, you cannot
62