Table of Contents
Advertisement
12 [Alarm] to set the alarm
12.4 [Alarm] to set alarm linkage operation
[Patrol 1]:When an alarm is detected by the motion detector, a patrol is started. *When Patrol 1
is not registered, it is not displayed.
[Scene change detection (SCD) alarm]
Select the action to be interlocked when an alarm is detected by the undesired signal detection
from the following.
[Off]:Interlock operation is not performed even if an alarm is detected by undesired signal detection.
1～256:When the preset position registered in advance is selected, the watch moves to the preset
position when an alarm due to disturbance detection is detected.
[Patrol 1]:When an alarm is detected by the disturbance detection, a patrol is started. *When
Patrol 1 is not registered, it is not displayed.
[Audio detection alarm]
Select the action to be linked to the alarm detected by the sound detection from the following.
[Off]:The product does not perform interlocked operation even if an alarm is detected by sound
detection.
1～256:When the preset position registered in advance is selected, the watch moves to the preset
position when an alarm is detected.
[Patrol 1]:When an alarm is detected by sound detection, patrol is started. *When Patrol 1 is not
registered, it is not displayed.
[Command alarm]
Select the action to be linked to the alarm by the command alarm from the following. This can be
set when [Command alarm] is set to [On].
[Off]:The product does not operate in conjunction with the command alarm.
1～256:Selecting the preset position registered in advance moves the camera to the position when
a command alarm is detected.
[Patrol 1]:When a command alarm is detected, a patrol is started. *When Patrol 1 is not
registered, it is not displayed.
Source-specific preset position:Register the address of the sender of the command alarm and the
preset position corresponding to that address, and move to that position when the alarm is
detected by the command alarm.
When [Preset per sender] is clicked, a separate window opens showing the settings for the
source-specific preset position.
→12.4.1 Set the preset position by source (screen for setting preset position by source)
Command Alarm Action-Source Address
The IP address of the PTZ camera for the Multi-directional/PTZ integrated camera is displayed.
Operation at Command AlarmInterlocked operation
Select the action linked to the command alarm when received from the following.
342
Advertisement
Table of Contents
