Table of Contents
Advertisement
12 [Alarm] to set the alarm
12.5 [VMD area] for setting motion detection
[1(White)] of [Area].
[Status]
Enable/disable operation detection.
[On]:Operation detection is performed.
[Off]:Operation detection is not performed.
[Detection area]
Set the area of the slider bar to detect movement of the subject in the motion detection area. The
smaller the set value, the smaller the movement of the subject is detected. The current setting (1
to 10) is displayed to the right of the slider bar.
[Detection sensitivity]
Use the slider bar to set the sensitivity for detecting movement in the area. Individual settings can
be made for each area. The larger the set value, the easier it is to sense the movement.
The current setting (1 (Low) to 15 (High)) is displayed under the slider bar.
[Delete] buttons
Click the area button to delete the area frame.
[Light detection control]
Use the [On] and [Off] buttons to specify whether or not the operation is not detected due to
changes in the illumination.
[Area No. notification]
Clicking [TCP alarm notification setup] displays the [Notification] tabs on the Alarm Page.
→12.1 [Alarm] to set alarm operation
Addition of motion detection information
[Information addition]
Adds motion detection information to images and sets on/off whether to transmit superimposed
image data. The operation detection information can be used by some of the search functions of
[Important]
・If the lighting intensity is small, it may be impossible to suppress it.
・When the illumination detection suppression is set to [On] and the subject with
movement throughout the screen is detected, the operation detection may not be
performed.
354
Advertisement
Table of Contents
