Table of Contents
Advertisement
16 [Maintenance] to maintain the machine
16.3 [Status] for checking the status
16.3
[Status] for checking the status
Click [Status] in the Maintenance page. Refer to the following how to display and operate the
Advanced menu.
→5.1 How to display
→5.2 How to operate
Here, you can check the status of the machine.
[Viewnetcam.com]
[Server]
The URLs for the [Viewnetcam.com] services server are displayed.
[Status]
This box indicates the registered status of [Viewnetcam.com] services.
*[xxxxxx] contains the software version.
・Do not turn off the computer during version upgrading.
・Do not perform any operation during version upgrading until the version upgrade
is completed.
・The following data will not be initialized even if [Initialize setup data after version
upgrade is completed] is selected.
IPv4 DNS primary server address, secondary server address, IPv6 primary server
address, DNS secondary server address, DHCP On/Off, IP address, subnet mask,
default gateway, HTTP port, HTTPS port, HTTP/HTTPS connection method,
CRT key, CA certificate, UPnP setting, communication rate, delivery rate control
(bit rate), time setting, IEEE802.1X setting, function extension software, and
function extension software setting
・Display plug-in software must be licensed for each PC. Contact your dealer for a
license.
[Note:]
・Please refer to our technical information website <Control No. C0111> for the
contents of the status display.
453
Advertisement
Table of Contents
