Table of Contents
Advertisement
14 Networking configuration [Network]
14.2 [Advanced] for advanced networking settings
[HTTPS-Select Certificate]
Select the certificate to use in HTTPS.
[Pre-install]:Select the pre-installation certificate.
CA:Select a CA certificate. This is displayed only if the CA certificate is installed.
[HTTPS-HTTPS port]
Set the port number to use for HTTPS.
Configurable port number:1～65535
The following port numbers cannot be set because they are used by this computer.
20、 21、 22、 23、 25、 42、 53、 67、 68、 69、 80 110、 123、 161、 162、 443、 554、 995、
1883、 8883、 10669、 10670、 59000～61000
[Pre-installation Certificate-Root Certificate Acquisition]
Clicking [Execute] downloads the route certificate for the pre-installation certificate. By installing
the root certificate on your PC, you can verify the signature of the pre-installation certificate.
[CA certificate-CRT key generate]
Creates a CRT key (SSL encryption key) for use in an HTTPS connection using a CA certificate.
CRT key generation is performed in [CRT key generation dialog] displayed when [Execute] is
clicked.
[CA Certificate-Generate Certificate Signing Request]
This generates a signature request (CSR Certificate Signing Request) to apply to a Certificate
Authority when using a security certificate issued by a CA (Certificate Authority) as a security
image is displayed.
・When you access the camera with HTTPS, the image may be distorted or the
sound may be interrupted.
・If you set the connectivity to [HTTPS], the maximum delivery is limited to 32Mbps.
・It is recommended that TLS 1.1 be disabled for security reasons.
・When TLS1.1 is enabled, TLS1.2 is also enabled.
・When TLS1.2 is disabled, TLS1.1 is also disabled.
・When you change the TLS1.2 setting, you need to reboot the camera. After
rebooting, you cannot perform operations for around 2 minutes, just as when the
camera is turned on.
[Note:]
・[MULTI] The port numbers 32768 to 49151 cannot be set.
416
Advertisement
Table of Contents
