Table of Contents
Advertisement
10 Set PTZ
10.3 Set auto-tracking (Auto-tracking screen)
Procedure for setting automatic tracking linkage
When two or more cameras with automatic tracking function are used, the tracking of objects can
be coordinated between the cameras.
(Automatic Tracking Coordination Function)
As an example, as shown in the figure below, the procedure for setting the connection from
Camera 1 (IP address: 192.168.0.11) to Camera 2 (IP address: 192.168.0.12) when the tracking
target enters the alarm area No.1.
When the subject moves directly below the camera
If flickering is severe
-reflection of light through windows, reflection of road surfaces, reflection of
backlight into the dome, etc.
When a tracking object is hidden in the pole or behind the object.
-when multiple subjects intersect or crowd
When the subject moves too fast or too slowly
-if the subject is too small or too large
If the camera is swaying
If the weather is very bad
-when the image correction function is ON
・It is recommended to use the product in the following installation environment to
increase the detection accuracy.
--more than about 1/5 (vertical) of the size of the monitor screen
・We shall not be liable for any inconvenience, damage, or damage caused by the
automatic tracking function settings or the results.
327
Advertisement
Table of Contents
