i-PRO WV-X86531-Z2-PTZ User Manual page 427

14 Networking configuration [Network]
14.2 [Advanced] for advanced networking settings
[SNMPv3]−[Authentication]
Displays the SNMPv3 authentication method.
[SNMPv3] − [Encryption method]
Select the SNMPv3 encryption method from DES/AES.
[SNMPv3] − [Password]
Set the SNMPv3 password.
Number of characters that can be entered:blank or 8-20 characters
Characters that cannot be entered:Double-byte and single-byte symbols " &
SNMPv2-MIB systemFixed
[System name]
Enter the device name to manage the machine using the SNMP function.
Number of characters that can be entered:0 to 32 characters
Characters that cannot be entered:Double-byte
[Location]
Enter the location where the machine was installed.
Number of characters that can be entered:0 to 32 characters
[Contact]
Enter the administrator's mail address or phone number.
Number of characters that can be entered:0 to 255 characters
Characters that cannot be entered:Double-byte
[SNMP trap settings]
Sets ON/OFF of SNMP trap notification.
[Destination of Trap] − [Address]
SNMP Enter the destination address for the trap notification.
Number of characters that can be entered:1 to 128 characters
Input Characters:One-byte alphanumeric and one-byte symbols : .
[Note:]
・If you upgrade while [MD5] is set in [Authentication], the [Authentication]
operates using [MD5]. Click the [Set] button to change [Authentication] to [SHA1].
[Important]
・IPv6 address and hostname cannot be used as the notification destination.
420