Alarm] For Setting The Output Terminal - i-PRO WV-U85402-V2L User Manual

4 Advanced settings
4.9 [Alarm] to set the alarm
4.9.2

[Alarm] for setting the output terminal

Click [Alarm] on the Alarm page. Refer to the following how to display and operate the Advanced
menu.
→4.2.1 How to display
→4.2.2 How to operate
Here, the output terminal is set.
Output terminal
For the output terminal function, the [Terminal 2] of the [Alarm] setting must be set to [Alarm
output].
[Terminal output upon alarm detection]
Sets on/off whether an alarm signal is output to the output terminal when an alarm is detected.
[SD memory card error]
The [On] or [Off] is used to determine whether to output signals to the output terminals when an
SD memory card alarm is detected.
SD Memory Card Alarm Detection Conditions: SD Memory Card error (write error, read error,
etc.), Operating time: 6 years, Overwrite count: 2,000 times
[On]:When the alarm condition is detected, a signal is output to the output terminal and [Alarm
notification] of the live picture is popupped.
[Off]:Stops detecting the alarm condition.
[Important]
・To use this function correctly, format the SD Memory Card on your computer
before using the SD Memory Card.
[Note:]
・Operation time: For 6 years, the power-on time after the SD card is inserted into
the camera, and for 2000 times, the upper limit of the number of business SD
Memory Card (MLC type) rewrites is used as a guide, and this does not guarantee
a durability period.
・The output terminal and SD Memory Card Alarm use the same output terminal.
・When either an alarm or SD Memory Card alarm is activated, a signal is output to
the output terminal.
313