Table of Contents
Advertisement
8 [Basic] for basic setup of the machine
8.1 [Basic] to perform basic settings
50%:The standard 50% size is displayed.
75%:Displays the standard 75% size.
100%:Displays the standard size.
150%:This is displayed as 150% of the standard size.
200%:Displayed as 200% of standard size.
[Brightness status display]
ON/OFF is used to set whether the brightness status is displayed when adjusting the brightness.
[Stabilizer]
ON/OFF is used to specify whether or not the camera's shaking correction function is enabled.
The gyroscope sensor can be used to compensate for low-frequency vibrations such as pole
vibrations caused by wind and fine vibrations at high magnification, thereby shooting images with
less blurring.
Use this function only when the camera is installed in an environment in which the camera
[Important]
・If the [Date/time position] and [Camera title position] settings are different, the
frame rate may be lower than the set value.
・If the [Date/time position] and [Camera title position] settings are different, the
characters may run out or overlap depending on the [Character size] setting and
the number of characters. Confirm the display results before use.
・If [Character size] is set to [150%] or [200%], the frame rate may be lower than
the set value.
・Depending on the [Character size] setting and the number of characters or the
resolution of the images, it may be displayed only halfway or difficult to read.
Confirm the display results before use.
[Note:]
・Even if 50% and 75% are set, the images of 640 x 360, VGA, 320 x 180, and
QVGA show 100% [Camera title on screen].
・If [Detailed setting] [Overlay] is set to [On], the date and time&Characters on
the Screen: You cannot set [150%] or [200%] in [Character size].
[Note:]
・The brightness display in the image is displayed when the brightness is adjusted
on the system device.
203
Advertisement
Table of Contents
