Table of Contents
Advertisement
8 [Basic] for basic setup of the machine
8.2 [SD memory card] for setting SD Memory Cards
[Storage interval/number of images (pre-alarm)] [Number of images to be saved]
Select the number of pre-alarm images to be saved to the SD Memory Card when an alarm is
generated.
[Off]/[1 pic]/[2 pics]/[3 pics]/[4 pics]/[5 pics]
[Storage interval/number of images (Post alarm)] [Image saving interval]
If [Save trigger] is set to [Alarm input] or [Manual], select the intervals below to save images to
the SD Memory Card.
When [Image capture mode] is set to 30 fps/15 fps: 0.1 fps/0.2 fps/0.33 fps/0.5 fps/1 fps
When [Image capture mode] is set to 25 fps/12.5 fps: 0.08 fps/0.17 fps/0.28 fps/0.42 fps/1 fps
[Storage interval/number of images (Post alarm)] [Number of images to be saved]
Select the number of alarm images to be saved to the SD Memory Card when an alarm is generated
from the following list.
[10 pics]/[20 pics]/[30 pics]/[50 pics]/[100 pics]/[200 pics]/[300 pics]/[500 pics]/[1000
pics]/[2000 pics]/[3000 pics]
Movie recording (when alarm is generated)
This setting is available only when the [Recording format] of the SD Memory Card is set to
streaming and [Save trigger] is set to [Alarm input].
[Pre alarm (recording) duration]
Select whether to record before alarm. Sets the time to save to the SD Memory Card.
[Off]/ [1s]/ [2s]/ [3s]/ [4s]/ [5s]/ [8s]/ [10s]/ [15s]/ [20s]/ [25s]/ [30s]/ [40s]/ [50s]/ [60s]/
[90s]/ [120s]
[Post alarm (recording) duration]
Sets the time to save to the SD Memory Card after an alarm is generated.
[10s]/ [20s]/ [30s]/ [40s]/ [50s]/ [60s]/ [120s]/ [180s]/ [240s]/ [300s]
[Note:]
・The values that can be set depend on the resolution and bit rate of the stream to
be recorded. The higher the bit rate, the smaller the maximum value that can be
set as the pre-alarm time.
216
Advertisement
Table of Contents
