Table of Contents
Advertisement
16 [Maintenance] to maintain the machine
16.3 [Status] for checking the status
[Personal(Camera) URL]
The URLs of cameras registered for the [Viewnetcam.com] services are displayed.
UPnP
Port number (HTTP), port number (HTTPS)
The port number configured for port forwarding in UPnP is displayed.
[Status]
The state of the port forwarding is displayed.
[Router global address]
The global address of the router is displayed.
[Self check]
The hardware self-diagnosis results are displayed.
[Operation information]
[Number of times of pan/tilt operation]
The number of PAN and TILT operations and the last replacement time are displayed.
Press the [Execute] button of the [Reset at the time of replacement] button to change the
operation count to zero and the last replacement time is updated.
[Number of times of zoom/focus operation]
The number of ZOOM and FOCUS operations and the last replacement time are displayed.
Press the [Execute] button of the [Reset at the time of replacement] button to change the
operation count to zero and the last replacement time is updated.
[Status]
The number of starts, energizing time, temperature sensor information, heater information, etc.
are displayed.
Active ClearSight
[Active ClearSight]
Press the [Execute] button to operate the camera at high speed to remove adhered water droplets.
[Note:]
・If you set [Viewnetcam.com] in [DDNS] on the [Advanced] tab of the Network
Page, the Network status is displayed.
[Note:]
・[PTZ] Only the PTZ camera is displayed as operation information.
454
Advertisement
Table of Contents
