Table of Contents
Advertisement
10 Set PTZ
10.3 Set auto-tracking (Auto-tracking screen)
1
Set the alarm area for the area for which automatic tracking is desired in Camera 1.
① The auto tracking setting screen is displayed.
② Select [On(In preset alarm area)] in [Auto track alarm] and press [Set].
③ In the Alarm area [Area select], select 1 from the [Area No.] pull-down.
④ While looking at the screen, perform pan tilt zoom to set the alarm area.
⑤ Press [Set].
2
Set the preset position to move when receiving the unique notification command in camera 2.
(Set the preset position so that the alarm area No.1 of Camera 1 set in step 1 enters the
screen.)
① The preset position setting screen is displayed.
→10.2.1 Set the preset position (preset position setting screen)
② Select the desired number from the [Preset] pull-down list.
③ While viewing the screen, set the preset position by using the pan tilt zoom.
④ Press [Register].
3
Set Camera 1 (IP address: 192.168.0.11) to notify the command.
① The Alarm Page [Notification] window is displayed.
→12.10 [Notification] to set alarm notification
② Set [TCP alarm notification] to [On] and press [Set].
③ In the [Destination of notification] [Notify Destination 1] (which may be selected), check
the [Alarm] checkbox and insert 192.168.0.12 in the [Destination address].
④ Set [Auto track cooperation] to [On] and select Alarm area No. 1.
⑤ Press [Set].
4
Set Camera 2 (IP address: 192.168.0.12) to receive the command.
① The Alarm Page [Alarm] window is displayed.
→12.1 [Alarm] to set alarm operation
② Set the [Alarm] [Command alarm] to [On] and press [Set].
③ Set the [Camera action on alarm] [Command alarm] to [Preset per sender] and press
[Preset per sender].
④ On the Preset by Source window, check Auto Tracking of [Source Address 1] (any Source
Address may be selected), enter the Source Address 192.168.0.11 (Camera 1), select the
preset position to move when receiving the command set in step 2, click [Set], and close
the pages.
→12.4.1 Set the preset position by source (screen for setting preset position by source)
⑤ Press [Set].
5
By starting the automatic tracking operation of camera 1, the automatic tracking linkage
function can be used.
328
Advertisement
Table of Contents
