i-PRO WV-X86531-Z2-PTZ User Manual page 475

18 Other
18.2 Trouble!?
Cannot be
accessed from a
Web browser
・Are cables of category 5e or higher connected to
the network connector?
・Check that the link lamp (LINK) is illuminated. If
it is not illuminated, the connection to the LAN is
not normal or the network to which the
connection is made is not operating normally.
Check the cable for faulty contact and wiring.
・Check that the power to the machine is ON and
that the power to the machine is ON.
・Are valid IP addresses set for your computer?
・Are incorrect IP addresses accessed? Confirm
the connection using the following method. In the
Windows command prompt>If Reply is returned
from your computer under ping [IP address set for
your computer], it is operating normally. If Reply
is not returned, check the connection using the
PC connected to the same network as the camera
as shown below. If the firewall setting of the PC is
enabled, temporarily cancel the firewall setting
before setting the camera.
Start the IP Easy Configuration Software, check
the camera IP address, and access the IP address.
If the network configuration (IP address, subnet
mask, default gateway) is incorrect, restart the
camera and change the network configuration
using the IP easy configuration software within 20
minutes.
In an environment without a • DHCP server,
restarting the computer with the Initialization
button sets the IP address to [192.168.0.10(*)].
Then access the computer to reset the IP address
(which initializes all settings).
The IP address of the (*) Multi-directional/PTZ
468
Operation Manual
Installation
Operation Manual
Installation
Operation Manual
Installation
14.1 Networking
[Network]
--