Table of Contents
Advertisement
2 Operation
2.4 Viewing images from mobile/tablet terminals
[On]:The Super Dynamic function is activated.
[Off]:Stops the superdynamic function.
⑧[Light control mode] pull-down menu
Select the mode to control the light intensity from the following.
[Flickless (50 Hz)]/[Flickless (60 Hz)]:Flicker is automatically corrected with a fluorescent
lamp. 50 Hz/60 Hz will be used differently in different regions.
[ELC]:The electronic shutter is used to control the light intensity.
⑨[Image Rotation]
Set whether to rotate the image (JPEG, H.265 or H.264).
0°(Off):The image is not rotated.
90°:Rotate the image 90 degrees.
180 degrees (vertical inversion):The image is inverted up and down.
270°:Rotate the image 270 degrees.
[Note:]
・Set [Super Dynamic] to [Off] when the following phenomena are observed
depending on the lighting condition.
-when flickering or color changes occur
-when noise is generated in the bright area of the screen
・When [Stabilizer] is set to [On], the superdynamic setting is [Off].
[Note:]
・When [Image capture mode] is 25fps, [Indoor scene(60Hz)] cannot be set.
[Important]
・If the image rotation setting is changed with the following area set, the position
will be misaligned. Therefore, set each area after setting image rotation.
-Privacy Zone
-Operation detection area
-Undesired detection area
-VIQS area
-Mask area
-overlay image
-Focus frame
91
Advertisement
Table of Contents
