Table of Contents
Advertisement
dC103 Billing Plan
Purpose
To change the tiered billing plan.
Procedure
Check that the correct SIM card is installed for the correct machine configuration, go to
Machine SIM Card Matrix.
1.
Enter Service Mode,
GP
1.
2.
Select the Maintenance tab.
3.
Select dC103 Billing Plan.
4.
Enter a valid billing plan authorization code.
5.
Follow the on screen instructions.
6.
Select Close to exit the routine.
7.
Select Call Closeout to exit Service Mode.
8.
Switch Off the machine and Switch On the machine,
To restore a customer's billing plan, use the following codes.
•
To restore a machine to a 1 tier billing plan use code 1791.
•
To restore a machine to a 2 tier billing plan use code 2487.
•
To restore a machine to a 3 tier billing plan use code 3258.
NOTE: These codes may be used to restore a customers billing plan if it should become cor-
rupted. To change a customers billing plan will require the Billing Plan Conversion Kit which the
customer will need to order from the Xerox sales department.
NOTE: It is not possible for the machine to run in the 3 tier billing plan if it is configured for Bill-
ing Impression mode.
ColorQube® 9303 Family
GP 19
GP
14.
February 2013
6-125
dC104 Usage Counters
Purpose
To display the various usage counters.
Procedure
1.
Enter Service Mode,
GP
1.
2.
Select the Service Info tab.
3.
Select dC104 Usage Counters.
4.
Select the relevant counters from the pull down menu.
5.
Select Close to exit the routine.
6.
Select Call Closeout to exit Service Mode.
General Procedures/Information
dC103, dC104
Advertisement
Chapters
Table of Contents
