Gp 28 Marking Unit Assembly Wiring Harnesses - Xerox ColorQube 9303 Series Service Manual

1
Rotate the motor gears to open the
cover shield and reveal the sensor.
Figure 1 IOD Assembly
Cleaning Unit and Abatement Plenum
Materials:
• Cleaning cloth, PL 26.10 Item 6.
• Cleaning fluid, PL 26.10 Item 1.
Procedure
1. Remove the cleaning unit, refer to
clean, dry cloth. Place the cleaning unit on several sheets of paper on a level surface.
Remove any paper debris from the metering blade.
2. Remove the abatement plenum, REP
cloth.
3. Reinstall the abatement plenum and then the cleaning unit.
ColorQube® 9303 Family
2
Clean the cover shield and the
sensor.
REP 94.1. Wipe the top and bottom surfaces with a
91.36. Clean the top surfaces with a clean, dry

GP 28 Marking Unit Assembly Wiring Harnesses

Purpose
To show the correct routing of the marking unit wiring harnesses.
Wire Routing
Figure 1 shows the correct harness routing along the upper and lower carriages.
shows the correct harness routing at the rear of the marking unit. Ensure the harnesses are
secured by the harness clamps. To move the marking unit into the service position, go to
NOTE: For clarity, the printheads are not shown in
service position in Figure 2.
February 2013
6-81
Figure 1. The marking unit is shown in the
Figure 1 Harness routing
General Procedures/Information
GP 27, GP 28
Figure 2
GP 6.