Omron R88M-1M Series User Manual page 43

Manual name
NJ-series CPU
Unit Hardware
User's Manual
NJ/NX-series CPU
Unit Software
User's Manual
NJ/NX-series CPU
Unit
Built-in Ether-
CAT® Port
User's Manual
NJ/NX-series CPU
Unit Motion Con-
trol User's Manual
AC Servomotors/Servo Drives 1S-series with Built-in EtherCAT® Communications User's Manual (I586)
Cat. No. Model numbers
W500 NJ501-
NJ301-
NJ101-
W501 NX701-
NX1P2-
NJ501-
NJ301-
NJ101-
W505 NX701-
NX102-
NX1P2-
NJ501-
NJ301-
NJ101-
W507 NX701-
NX1P2-
NJ501-
NJ301-
NJ101-
Application
Learning the basic speci- An introduction to the entire
fications of the NJ-series NJ-series system is provided
CPU Units, including along with the following infor-
introductory information, mation on the CPU Unit.
designing, installation,
• Features and system con-
and maintenance.
Mainly hardware infor-
• Introduction
mation is provided.
• Part names and functions
• General specifications
• Installation and wiring
• Maintenance and inspec-
Use this manual together
with the NJ-series CPU Unit
Software User's Manual
(Cat. No. W501).
Learning how to program The following information is
and set up an provided on a Controller built
NJ/NX-series CPU Unit. with an NJ/NX-series CPU
Mainly software informa- Unit.
tion is provided.
• CPU Unit operation
• CPU Unit features
• Initial settings
• Programming based on
Use this manual together
with the NX-series CPU Unit
Hardware User's Manual
(Cat. No. W535) or NJ-series
CPU Unit Hardware User's
Manual (Cat. No. W500).
Learning how to config- Describes setup procedures
ure the EtherCAT com- for building the EtherCAT
munications system. communications system.
Learning about motion The settings and operation of
control settings and pro- the CPU Unit and program-
gramming concepts. ming concepts for motion
control are described.
When programming, use this
manual together with the
NX-series CPU Unit Hard-
ware User's Manual (Cat.
No. W535) or NJ-series CPU
Unit Hardware User's Man-
ual (Cat. No. W500) and with
the NJ/NX-series CPU Unit
Software User's Manual
(Cat. No. W501).
Related Manuals
Description
figuration
tion
IEC 61131-3 language
specifications
41