Noise Filter Specifications; General Specifications - Omron R88M-1M Series User Manual

3-8

Noise Filter Specifications

Connect a noise filter to the input power supply for conformity to the EMC Directives.
For 1S-series Servo Drives, the Book-type and Footprint-type Noise Filters conform to the EMC Direc-
tives. (Noise filter manufacturer: Soshin electric Co., Ltd.) Select a noise filter according to the your sys-
tem.
The Footprint-type Noise Filter is attached to the back side of Servo Drive for the use, which can
decrease the installation area in the control panel. Select it according to the Servo Drive model and the
amount of the leakage current.
When a noise filter is used, install the surge absorber on the power supply input (LINE) side.
For the external dimensions, refer to 2-4-9 Noise Filter Dimensions on page 2-130.
For the Book-type Noise Filters, refer to Noise Filter for Power Input on page 4-58 in 4-3 Wiring Con-
forming to EMC Directives on page 4-47.
3-8-1

General Specifications

Item
Rated Voltage
Dielectric strength
Insulation resistance
Operating ambient tem-
perature and humidity
Storage ambient tempera-
ture and humidity
Operating and storage
atmosphere
UL standards
EU Directives (Low Volt-
age Directive)
AC Servomotors/Servo Drives 1S-series with Built-in EtherCAT® Communications User's Manual (I586)
R88A-FI1S1
Single-phase 100 to 240
VAC
Between power terminals and
PE terminals: 2,000 VDC for 1 min
Between power terminals and PE terminals: 500 MΩ min. (at 500 VDC)
0 to 55°C (Installed on a metal plate.), 90% max.(with no condensation)
-20 to 65°C, 90% max. (with no condensation)
No corrosive gases
UL 1283
EN 60939-2
Model
R88A-FI1S2
3-phase 200 to 240 VAC
3 Specifications
R88A-FI1S3
3-phase 380 to 480 VAC
Between power terminals
and PE terminals: 2,830
VDC for 1 min
3 - 135
3