Omron R88M-1M Series User Manual page 363

Dimen-
sion
S
40 mm min.
2
C R88D-1SN55H-ECT/-1SN75H-ECT/-1SN55F-ECT/-1SN75F-ECT
1
R88D-1SN150H-ECT/-1SN150F-ECT
C 50 mm min.
2
C 450 mm min.
3
• Install the Servo Drive on the vertical metal surface.
• To provide electrical conduction, remove any paint from the surface on which you install the Servo
Drives. Also, it is recommended that you apply conductive plating if you make the mounting bracket
by yourself.
• The recommended tightening torques for installing the Servo Drive are the followings. Make sure that
the threaded portion has the sufficient strength to withstand the recommended torque.
R88D-1SN55H-ECT/-1SN75H-ECT/-1SN55F-ECT/-1SN75F-ECT: Tightening torque 3 N·m
R88D-1SN150H-ECT/-1SN150F-ECT: Tightening torque 5.2 N·m
•
Set S distance over a value shown above table to install a Servo Drives.
2
AC Servomotors/Servo Drives 1S-series with Built-in EtherCAT® Communications User's Manual (I586)
4 Configuration and Wiring
Distance
130 mm min.
170 mm min.
4
4 - 5