Delta CFP2000 Series User Manual page 479

Chapter 13 Warning CodesCFP2000
ID No. Display on LCD Keypad
58
Action level
Action time
Warning setting parameter
Reset method
Reset condition
Record
Cause
The MC command is continuously
used for more than 9 times
ID No. Display on LCD Keypad
59
Action level
Action time
Warning setting parameter
Reset method
Reset condition
Record
Cause
PLC download is forced to stop, so
the program write-in is incompleted
Warning Name
PLC MCR error
PLC MCR command error
(PLCr)
Action and Reset
The MC command is detected during PLC operation, but there is no
corresponded MCR command, then the PLCr warning shows.
Immediately displays when the fault is detected
NA
Check if the program is correct and re-download the program. If the fault does
not exist, the warning automatically clears.
N/A
N/A
The MC command cannot be used continuously for 9 times. Check and reset the
program, then re-download the program.
Warning Name
PLC download fail
PLC download fail
(PLdF)
Action and Reset
PLC download fail due to momentary power loss during the downloading, when
power is ON again, PLdF warning shows.
Immediately displays when the fault is detected
NA
Check if the program is correct and re-download the program. If the fault does
not exist, the warning automatically clears.
N/A
N/A
Check if there is any error in the program and re-download the PLC program
13-28
Description
Corrective Actions
Description
Corrective Actions