Delta CFP2000 Series User Manual page 680

API
TADD
162
P
Bit device
X Y M K
S1
S2
D
Notes on operand usage:
Please refer to the function specifications table for each device in
series for the scope of device usage
: time addend. S
 S
1
The calendar data in hours, minutes, and seconds designated by S

calendar data in hours, minutes, and seconds designated by S
stored as hours, minutes, and seconds in the register designated by D.
If the value of S

command will not execute, M1067, M1068=On, and D1067 will record the error
code 0E1A (HEX).
If the results of addition are greater than or equal to 24 hours, carry flag

M1022=On, and D will display the results of addition minus 24 hours.
If the results of addition are equal to 0 (0 hours, 0 minutes, 0 seconds), zero flag

M1020=On.
When X10=On, the TADD command will be executed, and the calendar data in

hours, minutes, and seconds designated by D0 to D2 will be added to the calendar
data in hours, minutes, and seconds designated by D10 to D12, and the results are
stored as a total number of hours, minutes, and seconds in the registers
designated by D20 to D22.
X10
Word device
H KnX KnY KnM T
＊
＊
＊
: time augend. D: time sum.
2
or S exceeds the range, this is considered an operating error, the
1 2
TADD D0
Chapter 16 PLC Function Applications│CFP2000
Calendar data addition
16-bit command (7 STEP)
TADD Continuous
C D
execution type
＊ ＊
＊ ＊
32-bit command
＊ ＊
－

Flag signal:
D10 D20
16-107
TADDP Pulse
execution type
－ － －
M1020 Zero flag
M1022 Carry flag
M1068 Calendar error
is added to the
2
, and the result is
1