Table of Contents
Advertisement
Chapter 8 Option Cards CFP2000
Please select applicable option cards for your drive or contact local distributor for suggestion.
To prevent drive damage during installation, please remove the digital keypad and the cover before wiring.
Refer to the following instruction.
8-1 Option Card Installation
8-1-1 Remove the top cover
Frame A & B
Screw Torque: 12–15 kg-cm / [10.4–13 lb-in.] / [1.2–1.5 Nm]
1. Remove the keypad (as shown in below figure 2).
2. Loosen the screws, then remove the top cover (as shown in below figure 3).
Figure 1
Frame C
Screw Torque: 12–15 kg-cm / [10.4–13lb-in.] / [1.2–1.5 Nm]
1. Remove the keypad (as shown in below figure 2).
2. Loosen the screws, then remove the top cover (as shown in below figure 3).
Figure 1
Figure 2
Figure 2
8-2
Figure 3
Figure 3
Advertisement
Table of Contents
