Delta CFP2000 Series User Manual page 255

Chapter 12 Description of Parameter SettingsCFP2000
 You can set 17 to monitor the digital output status, and then set 20 to check if the circuit is
normal.
 Explanation 4
Setting value 25: when displayed value reaches 100.00%, the drive shows "oL" as an overload
warning.
 Explanation 5
Setting value 38:
bit 0: The drive is running forward.
bit 1: The drive is running backward.
bit 2: The drive is ready.
bit 3: Errors occurred on the drive.
bit 4: The drive is running.
bit 5: Warnings occurred on the drive.
Coefficient Gain in Actual Output Frequency

Settings 0.00–160.00
 Sets the user-defined unit coefficient gain. Set Pr.00-04= 31 to display the calculation result on
the screen (calculation = output frequency * Pr.00-05).
Software Version
Settings Read only
Parameter Protection Password Input

Settings 0–65535
Display
 This parameter allows you to enter your password (which is set in Pr.00-08) to unlock the
parameter protection and to make changes to the parameter.
 To avoid problems in the future, be sure to write down the password after you set this parameter.
 Pr.00-07 and Pr.00-08 are used to prevent personnel from setting other parameters by accident.
 If you forget the password, clear the password setting by entering 9999 and press the ENTER
key, then enter 9999 again and press ENTER within 10 seconds. After decoding, all the settings
return to default.
 When setting is under password protection, all the parameters read 0, except Pr.00-08.
Parameter Protection Password Setting

Settings 0–65535
 This parameter is for setting the password protection. Password can be set directly the first time.
After you set the password, the value of Pr.00-08 is 1, which means password protection is
0–4 (the number of password attempts)
0: No password protection or password entered correctly (Pr.00-07)
1: Password has been set
12.1-00-4
Default: 1.00
Default: Read only
Default: 0
Default: 0