Delta CFP2000 Series User Manual page 438

 Group setting 04: Pump
The following table lists the relevant pump setting application parameters.
Pr.
00-11 Speed control mode
00-16 Load selection
Master frequency command source (AUTO)
00-20
/ Source selection of the PID target
00-21 Operation command source (AUTO)
00-23 Control of motor direction
01-00 Maximum operation frequency
01-01 Output frequency of motor 1
01-02 Output voltage of motor 1
01-03 Mid-point frequency 1 of motor 1
01-04 Mid-point voltage 1 of motor 1
01-05 Mid-point frequency 2 of motor 1
01-06 Mid-point voltage 2 of motor 1
01-07 Minimum output frequency of motor 1
01-08 Minimum output voltage of motor 1
01-10 Output frequency upper limit
01-11 Output frequency lower limit
01-12 Acceleration time 1
01-13 Deceleration time 1
01-43 V/F curve selection
07-06 Restart after momentary power loss
07-11 Number of times of restart after fault
07-33 Auto-restart interval of fault
 Group setting 10: Air Handling Unit, AHU
The following table lists the relevant AHU setting application parameters.
Pr.
00-04 Content of multi-function display
00-11 Speed control mode
00-16 Load selection
Master frequency command source (AUTO)
00-20
/ Source selection of the PID target
00-21 Operation command source (AUTO)
00-22 Stop method
00-23 Control of motor direction
00-30 Master frequency command (HAND) source
00-31 Operation command (HAND) source
Chapter 12 Description of Parameter SettingsCFP2000
Explanation
Explanation
12.1-13-3
Settings
0 (V/F mode)
0: Light load
2: External analog input
1: External terminals.
1: Disable reverse
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
50 (Hz)
35 (Hz)
15 (s)
15 (s)
2: 2 V/F curve
nd
2: Speed tracking by minimum output
frequency
5 (times)
60 (s)
Settings
2
0 (V/F control)
0: Light load
2 or 0 (External analog input)
1 or 0 (External terminals)
1: Coast to stop
1: Disable reverse
0: Digital keypad
0: Digital keypad