Delta CFP2000 Series User Manual page 85

Chapter 6 Control TerminalsCFP2000
6-3 Remove the Terminal Block
1. Loosen the screws by screwdriver. (As shown in figure below).
Screw torque: 6–8 kg-cm / [5.2–6.9 lb-in] / [0.59–0.78 Nm]
2. Remove the control board by pulling it out for a distance 6
board upward (as 2 in the figure).
Figure 6-23
8 cm (as 1 in the figure) then lift the control
–
1
2
Figure 6-24
6-10