Delta CFP2000 Series User Manual page 352

Capacitance Temperature at Malfunction
Settings
 When a malfunction occurs, check the current capacitance temperature. If it happens again, it
overwrites the previous record.
Motor Speed in rpm at Malfunction
Settings
 When a malfunction occurs, check the current motor speed in rpm. If it happens again, it
overwrites the previous record.
Status of Multi-function Input Terminal at Malfunction
Settings
Status of Multi-function Output Terminal at Malfunction
Settings
 When a malfunction occurs, check the status of multi-function input / output terminals. If it
happens again, it overwrites the previous record.
Drive Status at Malfunction
Settings
 When a malfunction occurs, check the current drive status (communication address 2101H). If it
happens again, it overwrites the previous record.
STO Latch Selection

Settings
 Pr.06-44=0: STO Alarm latch. After you clear the cause of the STO Alarm, use a Reset command
to clear the STO Alarm.
 Pr.06-44=1: STO Alarm no latch. After you clear the cause of the STO Alarm, the STO Alarm
clears automatically.
 All of STL1–STL3 errors are "Alarm Latch" mode (in STL1–STL3 mode, the Pr.06-44 function is
no effective).
Treatment to Output Phase Loss (OPHL)

Settings
 The OPHL protect function is active when the setting is not 3.
-3276.7–3276.7°C
-32767–32767 rpm
0000h–FFFFh
0000h–FFFFh
0000h–FFFFh
0: STO latch
1: STO no latch
0: Warn and continue operation
1: Fault and ramp to stop
2: Fault and coast to stop
3: No warning
12.1-06-16
Chapter 12 Description of Parameter SettingsCFP2000
Default: Read only
Default: Read only
Default: Read only
Default: Read only
Default: Read only
Default: 0
Default: 3