Table of Contents
Advertisement
Parameter
Pr.09-80
Pr.09-81
Pr.09-82
Pr.09-83
Pr.09-84
Pr.09-85
Pr.09-86
Pr.09-87
8-9-6 LED Indicator & Troubleshooting
There are 2 LED indicators on CMC-EIP01: POWER LED and LINK LED. The POWER LED
displays the status of power supply, and the LINK LED displays the connection status of the
communication.
LED Indicators
LED
POWER
Green
LINK
Green
Troubleshooting
Abnormality
POWER LED OFF
LINK LED OFF
No communication
card found
Fail to open
CMC-EIP01 setup
page
Function
Netmask -1
Netmask -2
Netmask -3
Netmask -4
Default gateway -1
Default gateway -2
Default gateway -3
Default gateway -4
Status
ON
Power supply in normal status
OFF
No power supply
Network connection in normal
ON
status
Flashes
Network in operation
OFF
Network not connected
Cause
AC motor drive not powered
CMC-EIP01 not connected to
AC motor drive
CMC-EIP01 not connected to
network
Poor contact to RJ45
connector
CMC-EIP01 not connected to
network
PC and CMC-EIP01 in
different networks and blocked
by network firewall.
CMC-EIP01 not connected to
network
Incorrect communication
setting in DCISoft
PC and CMC-EIP01 in
different networks and blocked
by network firewall.
Set value (Dec)
255
Netmask 255.255.255.0
255
Netmask 255.255.255.0
255
Netmask 255.255.255.0
0
Netmask 255.255.255.0
192
Default gateway 192.168.1.1
168
Default gateway 192.168.1.1
1
Default gateway 192.168.1.1
1
Default gateway 192.168.1.1
Indication
Check if AC motor drive is powered, and if the
power supply is normal.
Make sure CMC-EIP01 is connected to AC motor
drive.
Make sure the network cable is correctly connected
to network.
Make sure RJ45 connector is connected to
Ethernet port.
Make sure CMC-EIP01 is connected to network.
Search by IP or set up relevant settings by AC
motor drive keypad.
Make sure CMC-EIP01 is connected to the
network.
Make sure the communication setting in DCISoft is
set to Ethernet.
Conduct the setup by AC motor drive keypad.
8-21
Chapter 8 Option Cards CFP2000
Explanation
How to correct it?
--
Check the power supply.
--
--
Check if the network cable is
connected.
How to correct it?
Advertisement
Table of Contents
