Delta CFP2000 Series User Manual page 211

Chapter 11 Summary of Parameter SettingsCFP2000
Pr. Parameter Name
 00-03 Start-up display selection
Content of multi-function display
 00-04
(user-defined)
Coefficient gain in actual output
 00-05
frequency
Settings Range
0: F (frequency command)
1: H (output frequency)
2: U (user-defined, see Pr.00-04)
3: A (output current)
0: Display output current (A) (Unit: Amp)
1: Display counter value (c) (Unit: CNT)
2: Display actual output frequency (H.) (Unit: Hz)
3: Display DC bus voltage (v) (Unit: V
4: Display output voltage (E) (Unit: V
5: Display output power angle (n) (Unit: deg)
6: Display output power in kW (P) (Unit: kW)
7: Display actual motor speed rpm (r) (Unit: rpm)
10: Display PID feedback (b) (Unit: %)
11: Display AVI1 in % (1.) (Unit: %)
12: Display ACI in % (2.) (Unit: %)
13: Display AVI2 in % (3.) (Unit: %)
14: Display temperature of IGBT (i.) (Unit: °C)
15: Display temperature of capacitance (c.)
(Unit: °C)
16: The status of digital input (ON / OFF) (i)
17: The status of digital output (ON / OFF) (o)
18: Multi-step speed (S)
19: The corresponding CPU pin status of digital input
(d)
20: The corresponding CPU pin status of digital
output (0.)
26: Ground fault GFF (G.) (Unit: %)
27: DC bus voltage ripple (r.) (Unit: V
28: Display PLC register D1043 data (C)
30: Display output of user-defined (U)
31: Display Pr.00-05 user gain (K)
34: Operation speed of fan (F.) (Unit: %)
36: Present operating carrier frequency of drive (J.)
(Unit: Hz)
38: Display drive status (6.)
41: kWh display (J) (Unit: kWh)
42: PID target value (h.) (Unit: %)
43: PID offset (o.) (Unit: %)
44: PID output frequency (b.) (Unit: Hz)
45: Hardware ID
51: PMSVC torque offset
52: AI10%
53: AI11%
68: STO version
69: STO checksum high
70: STO checksum low
0.00–160.00
11-2
Default
0
)
DC
)
AC
3
)
DC
1.00