Delta CFP2000 Series User Manual page 281

Chapter 12 Description of Parameter SettingsCFP2000
Settings Functions
5 Reset
6 JOG Command
Acceleration /
7 deceleration speed
inhibit
The 1 ,
st
8 or deceleration time
selection
The 3 , 4
rd
9 or deceleration time
selection
EF Input
10
(EF: External fault)
Use this terminal to reset the drive after clearing a drive fault.
This function is valid when the source of the operation command is
the external terminals.
The JOG operation executes when the drive stops completely.
When the STOP key on the digital keypad is enabled (Pr.00-32),
you can stop the drive through the digital keypad. Once the external
terminal receives the OFF command, the motor stops in the JOG
deceleration time. Refer to Pr.01-20–01-22 for details.
When you enable this function, the drive stops acceleration and
deceleration immediately. After you disable this function, the AC
motor drive starts to accelerate or decelerate from the inhibit point.
2 acceleration
nd
You can select the acceleration and deceleration time of the drive
with this function, or from the digital status of the terminals; there
are four acceleration and deceleration selection.
acceleration
th
For external fault input. The drive decelerates according to the
Pr.07-20 setting, and the keypad shows EF. (It shows the fault
record when an external fault occurs). The drive keeps running until
the fault is cleared (terminal status restored) after RESET.
Descriptions
MIx=9 MIx=8
OFF OFF
OFF ON
ON OFF
ON ON
12.1-02-4
Accel./Decel.
1 st Accel./Decel.
2 Accel./Decel.
nd
3 rd Accel./Decel.
4 Accel./Decel.
th