Delta CFP2000 Series User Manual page 214

Pr. Parameter Name
00-26 Max. user defined value
00-27 User-defined value
Switching from Auto mode to Hand
 00-28
mode
00-29 LOCAL / REMOTE selection
Master frequency command source
00-30
(HAND)
Operation command source
00-31
(HAND)
00-32 Digital keypad STOP function

00-48 Display filter time (Current)

Chapter 11 Summary of Parameter SettingsCFP2000
Settings Range
0: No function
0–65535 (when Pr.00-25 set to no decimal place)
0.0–6553.5 (when Pr.00-25 set to 1 decimal place)
0.00–655.35 (when Pr.00-25 set to 2 decimal places)
0.000–65.535 (when Pr.00-25 set to 3 decimal
places)
Read only
bit0: Sleep function control bit
0: Cancel sleep function
1: Sleep function and Auto mode are the same
bit1: Control bit unit
0: Displaying unit in Hz
1: Same unit as the Auto mode
bit2: PID control bit
0: Cancel PID control
1: PID control and Auto mode are the same
bit3: Frequency source control bit
0: Frequency source set up by parameter, if the
multi-step speed is activated, then
multi-speed has the priority.
1: Frequency command set up by Pr.00-30,
regardless of whether the multi-step speed is
activated.
0: Standard HOA function
1: Switching Local / Remote, the drive stops
2: Switching Local / Remote, the drive runs as the
REMOTE setting for frequency and operation
status
3: Switching Local / Remote, the drive runs as the
LOCAL setting for frequency and operation status
4: Switching Local / Remote, the drive runs as
LOCAL setting when switched to Local and runs
as REMOTE setting when switched to Remote for
frequency and operation status.
0: Digital keypad
1: RS-485 serial communication
2: External analog input (Pr.03-00)
3: External UP / DOWN terminal
6: CANopen communication card
8: Communication card (no CANopen card)
0: Digital keypad
1: External terminals
2: RS-485 serial communication
3: CANopen communication card
5: Communication card (no CANopen card)
0: STOP key disable
1: STOP key enable
0.001–65.535 sec.
11-5
Default
0
Read
only
0
0
0
0
0.100