Chapter 10 Digital Keypad - Delta CP2000 Series User Manual

KPC-CC01
Descriptions of Keypad Functions
Key
Start Operation Key
1.
2.
3.
4.
Stop Command Key. This key has the highest processing priority in any situation.
1.
2.
Operation Direction Key
1.
2.
ENTER Key
Press ENTER and go to the next level. If it is the last level then press ENTER to execute the command.
ESC Key
ESC key function is to leave current menu and return to the last menu. It is also functioned as
a return key in the sub-menu.
10 Digital Keypad
KPC-CE01(Option)
It is only valid when the source of operation command is from the keypad.
It can operate the AC motor drive by the function setting and the RUN LED will be ON.
It can be pressed again and again at stop process.
When enabling "HAND" mode, it is only valid when the source of operation command is
from the keypad.
When it receives STOP command, no matter the AC motor drive is in operation or stop
status, the AC motor drive needs to execute "STOP" command.
The RESET key can be used to reset the drive after the fault occurs. For those faults that
can't be reset by the RESET key, see the fault records after pressing MENU key for
details.
This key is only control the operation direction NOT for activate the drive. FWD: forward,
REV: reverse.
Refer to the LED descriptions for more details.

Communication Interface
RJ-45 (socket)、RS-485 interface;

Installation Method
Embedded type and can be put flat on the surface
of the control box. The front cover is water proof.

Charge the digital keypad for 6 minutes
before you use it to program Delta's AC
Motor Drive.

What's new at KPC-CC01 keypad?
-It supports calendar function of PLC ( See
Chapeter 17 for more infomation about PLC.)
-The available editing pages reach the maximum
number of pages supported by TP Editor.
-TP Editor v.140.1 is required
-It supports VFDSoft to read parameters. Please
go to http://www.delta.com.tw/ to download
VFDSoft v1.45.
Descriptions
10-1

Chapter 10 Digital Keypad