Table of Contents
Advertisement
07 Special Parameters
Pr.
Parameter Name
07-00
Built-in Software brake level
07-01
DC brake current level
07-02
DC brake time at run
07-03
DC brake time at stop
07-04
DC brake frequency at stop
07-05
Voltage increasing gain
Restart after momentary power
07-06
loss
07-07
Allowed power loss duration
07-08
Base block time
07-09
Current limit of speed tracking
07-10
Restart after fault action
Number of times of restart after
07-11
fault
07-12
Speed tracking during start-up
07-13
dEb function selection
07-15
Dwell time at acceleration
07-16
Dwell frequency at acceleration
07-17
Dwell time at deceleration
07-18
Dwell frequency at deceleration
07-19
Fan cooling control
Chapter 11 Summary of Parameter SettingsCFP2000
Setting Range
700.0–900.0 V
DC
0–100%
0.0–60.0 sec.
0.0–60.0 sec.
0.00–599.00 Hz
1–200%
0: Stop operation
1: Speed tracking by speed before the power loss
2: Speed tracking by minimum output frequency
0.0–20.0 sec.
0.0–5.0 sec. (Depending on the model power)
20–200% (100% corresponds to the light-load rated
current of the drive)
0: Stop operation
1: Speed tracking by current speed
2: Speed tracking by minimum output frequency
0–10
0: Disable
1: Speed tracking by maximum output frequency
2: Speed tracking by motor frequency at start
3: Speed tracking by minimum output frequency
0: Disable
1: dEb with auto acceleration / deceleration, the drive
does not output the frequency after the power is
restored.
2: dEb with auto-acceleration / auto-deceleration, the
drive outputs the frequency after the power is
restored.
0.00–600.00 sec.
0.00–599.00 Hz
0.00–600.00 sec.
0.00–599.00 Hz
0: Fan always ON
1: Fan is OFF after the AC motor drive stops for one
minute
2: Fan is ON when AC motor drive runs; fan is OFF
when AC motor drive stops
3: Fan turns ON when temperature (IGBT) reaches
around 60°C.
4: Fan always OFF
11-27
Default
740.0
0
0.0
0.0
0.00
100
0
2.0
Depending
on the
model
power
100
0
0
0
0
0.00
0.00
0.00
0.00
0
Advertisement
Table of Contents
